Pay in installments of $7.14 with
,
and
Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Aug 4 - Aug 9
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
pop up 4 season tent Hub 4XL TentHUB 4XL 64 square feet. Four pull tabs. Deploys in minutes. Perfect for: Base camp setups Overlanding families & groups 4 season use RTT pairings for extra sleeping capacity Pop up hub tents are convenient. The problem is that most stop there thin walls, no insulation, nowhere to run a stove. The Hub 4XL is built differently. An 8' 8' footprint with Tri Layer insulated walls and door, a 3" integrated stove jack, a removable floor, and a pull tab
HUB 4XL — 64 square feet. Four pull tabs. Deploys in minutes.
Perfect for: Base camp setups · Overlanding families & groups · 4-season use · RTT pairings for extra sleeping capacity
Pop-up hub tents are convenient. The problem is that most stop there — thin walls, no insulation, nowhere to run a stove. The Hub 4XL is built differently. An 8' × 8' footprint with Tri-Layer insulated walls and door, a 3" integrated stove jack, a removable floor, and a pull-tab deployment that only takes a few minutes. It's the ground tent that earns a place in an overlanding kit, not just a car camping weekend.
Features:
- Four Pull Tabs. Deployed in Minutes. Four pull tabs release the hub structure and the integrated front door drops into position supported by three poles — no separate pole assembly, no reading instructions in the dark. The rainfly and floor are optional and removable, so you configure it for the conditions you're actually in.
- Tri-Layer Walls & Door — Insulated, 100% Waterproof The roll-up walls and integrated door use FSR's patented Tri-Layer construction — polycotton fill sonic-welded between two waterproof layers. They hold warmth in when it's cold and keep heat out when it's hot. The ceiling uses a standard rainfly for weather protection; for serious cold-weather use, pair with a wood burner through the stove jack.
- 3" Integrated Stove Jack A built-in 3" port in the ceiling lets you run a wood burner or cooking stove safely inside the tent. It's the feature that pushes the Hub 4XL from a three-season shelter into genuine cold-weather base camp territory when you need it.
- Removable Floor The floor comes out when you don't need it — useful for cooking setups, sandy or wet conditions, or connecting to the Car Connect accessory for a seamless vehicle-to-tent footprint extension.
- Integrated PVC Window A clear PVC panel on the door gives you a view and natural light when the weather closes in. An interior blackout panel zips over it when you want to sleep in.
- Half Rainfly = Ventilation + Protection The half rainfly covers the roof without blocking airflow from the roll-up walls, which means you get weather protection and ventilation running at the same time. No condensation buildup from a fully sealed tent.
- Dimmable LED Light Strip Included Built-in dimmable LED lighting for late nights and early mornings — already in the box, no separate purchase required.
Specs:
- Capacity: 4–6 people
- Floor space: 64 sq ft (96" × 96")
- Interior height: 80"
- Door dimensions: 41" W × 67" H
- Weight: 42 lbs
- Packed: 70" L × 12" W × 10" H
- Stove jack: 3" integrated ceiling port
- Compatible with: Car Connect
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.3 ★★★★★
Based on 17 reviews
Sort
Product Reviews
★★★★★ 5
Great Instructions, Straightforward Assembly
Color: Black
I just received this chair today, so my product review is mostly on the packaging, instructions, and assembly.
The product was well-packaged, and it was obvious when I unboxed it that a lot of care and thought went into packing it in the most efficient way that would also protect the parts. I was positively impressed with the packaging.
I was also incredibly impressed with the instructions and assembly process. I am used to cheaper products where the parts only half fit or important components are missing, or where the instructions were confusing and unclear. This chair's instruction manual was very clear and concise. The diagrams were easy to understand and neat. The screws came labeled and separated and also included the scew types and sizes/lengths, which is handy in case you need to pick up extras at a store somewhere. But they also included one extra of each type of screw, washer, and cover, which I appreciated during assembly. (I didn't find myself worrying what would happen if I dropped a screw, which is something I would normally be distsracted by while working.)
The only things I would take points off for were these:
1. The instructions said the chair came with gloves for assembly, but no gloves were included. That was fine with me, but why mention them if you won't include them? The instructions even later say not to use the chair if not all components were present...but all the important ones were, so I assembled it without gloves (as I probably would have done anyway, since it was for me and not another person).
2. It matters which side of the seat is the front, but the sticker was confusing. The instructions show a sticker placed on the side that is the front, and that is where my sticker was placed. However, the sticker says "FRONT" and has an arrow pointing somewhere. In the instructions this arrow pointed to the front. On my seat, however, the arrow pointed to the back. So am I supposed to believe the sticker placement (it was diagonal, so it looked haphazardly slapped on) or the arrow? On that particular step the piece you are screwing into the seat can fit both ways, but thankfully there is a later step where it becomes obvious which side is the front vs. the back. (The arm rests can only be attached to the back.) So I wish that had been clearer up front, but otherwise it was okay.
Recommendations for assembly:
- To attach the wheels, apply firm, direct, straight-down pressure. I tried screwing them on at first but you just push. Make sure they go in the whole way like the picture shows.
- When they say to tighten the screws to only 60%, it's a helpful tip, because you can't fit the armrests on both the seat and chairback at the same time with the screws completely tightened. Just tighten them enough to fit the pieces on, then later you can tighten up the screws.
So far I find the chair to be very comfortable and I'm exceedingly happy with it. The lumbar support seems like it could potentially be a little chafy or scratchy, but I'll give the chair a chance before deciding if it's problematic or not. Like I said, I only got the chair today, so I can't speak much to its long-term comfort, durability, or longevity. But I was so impressed with how easy and straightforward they made the assembly that I had to write a review to show my appreciation.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 9, 2026
★★★★★ 3
It's okay
Color: Black
Appeared to be a super comfortable chair. Purchased for my mother to work from home and the material is apparently slightly itchy and the arm rest isn't quite comfortable. It was pretty simple to put together but it did take some time.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on June 11, 2026
★★★★★ 5
An Actual Nice Chair for a Decent Price. +2 for the Tool.
Color: Black Grey
Welp, My old chair finally broke, so It was time for a new one. I ended up coming across this chair here, and I couldn't really find anyone talking about it online. I decided to give it a shot since it was on a good sale for Christmas, going down to 99$. I'm going to be honest, I am pleasantly surprised. The cushioning for it is a little firm, but that is perfect for me. Its pretty average when it comes to office chairs, but having the added lower back support is a great touch. I have no complaints about it.
The one thing that I am actually really happy about isn't on the chair. Don't get me wrong, over the week I have been using it, It has been nothing but great. That thing is the actual tool it came with. Its a basic Allen key, but the top of it is a molded handle instead of a "L" piece of metal. It made the already easy process of putting together this chair even better. Even after this chair has ran its course like all other chairs, I'm going to still use this tool.
So yeah, I think 5 - stars pretty accurately describes how I feel about my chair.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on January 2, 2026
★★★★★ 5
Comfortable chair that works great for long hours
Color: Black
I’ve been using this office chair for a few days and it’s been very comfortable for working and longer desk sessions. The high back design and ergonomic support help maintain good posture, while the cushioning stays comfortable throughout the day. The chair feels sturdy and stable, and the 330 lb capacity gives it a solid, durable feel. It also rolls smoothly and quietly, which is nice when moving around the workspace without creating a lot of noise. Overall, it was easy to assemble, looks professional, and offers great value for the money.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on June 10, 2026
★★★★★ 5
Very Comfortable Ergonomic Chair - Great for Long Work Days!
Color: Black, Color: Black
I’ve been using this ergonomic office chair for a couple of weeks now and I’m genuinely impressed. For the price, it offers excellent comfort and support.
What I like:
• Very comfortable padded seat and backrest — I can sit for 8+ hours without back pain.
• Good lumbar support and adjustable height/armrests.
• Holds up to 330 lbs easily (I’m 240 lbs and it feels very stable).
• Smooth rolling wheels and sturdy base.
• Easy to assemble (took about 20 minutes).
The mesh back breathes well and doesn’t get hot. It looks professional in my home office too.
Overall, this is a solid ergonomic chair. If you spend a lot of time at a desk, I highly recommend it.
Would I buy it again? Yes, definitely.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 12, 2026
recommand products
SHIMANO ULTEGRA R8000 11-fach Komplettgruppe Rennrad Disc NEU
29.20
HENMI Fahrradtasche Rahmen, wasserdichte Rahmentasche Dreieckstasche,
24.17
Rovativ® Bikepacking Rahmentasche [2,2 Liter] 100% Wasserdicht - super Fester Halt - Robustes TPU-Gewebe - 2 Fächer
27.10
Stevens Stelvio Pro – Der ReCyclist
21.54
Rose Reveal 04 Ultegra Di2 Rennrad Generalüberholt aus zweiter Hand Rennrad – H&B Exclusive
20.00